Float Mounting Artwork in a Frame Using Mat Board

Written by Joely Rogers

Float-mounting is a mounting technique where the edges of the artwork are left uncovered. When mounted this way, the artwork appears to be floating within the frame or mat board window. Float-mounting is normally used when the image goes all the way to the edge of paper and you don’t want any of it covered. It’s also a great way to show off paper with deckled or torn edges.

How to Float Mount Your Artwork

1. Measure Your Art, Obtaining the Width & Height

Artwork

Determine how much visible area you want around the matboard and then calculate the uncut matboard size.

A common question I get with regards to float-mounting is “How much space should be left around the art?” There’s no right or wrong answer, but typically I like between 1/2" – 2 inches of space. For this image, I decided not to use a mat. I went with a 2-inch visible border around the art using an uncut blank mat board as the backing.

2. Calculate the Outside Dimension

Image sizes are normally expressed as width by height (width” x height”). The “sign stands for inches. Keep in mind; however, that you are dealing with four sides. *Remember to double whatever number you are adding to each side.

For example:

Artwork size = 9” x 12”

Desired visible area = 2 inches

CalculateUncutDimension

3. Pick Out Uncut Mat

Finally, it’s time to mount using tape for hinging floating artwork

We are using a v-hinge; which looks exactly like the t-hinge, except the tape is completely hidden under the artwork.

When you hinge artwork it’s preferable to hinge the top only, allowing the bottom to hang free. This allows the paper to expand and contract with temperature changes. However, if your paper is warped and just won’t lie flat, you can also add a small hinge at the bottom. Let’s get started!

Flip your artwork over keeping the top of the image close to you. Cut 4 strips of Self-Adhesive Linen Hinging Tape. The length of the strips depends on the size of your artwork. If your paper is less than 30 inches, 1 – 4 inches is typically fine.

1192

Make your first hinge; remove the paper backing from one of the strips and place it in the top corner – vertical, with the sticky side UP. Remove the paper backing from a second piece and place it horizontally, sticky side DOWN across the top. It should look like a capital “T”. The bottom edge of the “T” should be slightly lower than the top edge of the paper. Repeat on the other side with the remaining 2 strips of tape.

1193
1197

Closeup of the hinge. *Note – if your paper is very wide, you may need 3 or more hinges across the top.

1196

Flip your artwork over and carefully center it on the uncut matboards. Do not press down on the hinged area until it is properly centered. Using a tape measure to check the border sizes is the most accurate way of centering.

1202
1199

Once your artwork is centered, gently smooth the top edge of paper to create the adhesion.

1201

Frame your floated artwork in your favorite wood or metal picture frame!

FramedArtwork

Products We Used

Uncut Mat Board – Bainbridge 4-ply Alphamat in Mimosa

Frame – Nielsen Profile 24 in Brushed Satin German Silver